1. Before processing each program, it is necessary to strictly confirm whether the tool on the program is consistent with the program.
2. When installing the tool, make sure that the length of the tool and the selected tool holder are suitable.
3. It is forbidden to open the door during the operation of the machine tool to avoid flying knife or workpiece.
4. If a tool collision is found during processing, the operator must stop immediately, such as pressing the "emergency stop" button or the "reset button" or adjusting the "feed rate" to zero.
5. In the same workpiece, each time the tool needs to be kept in the same area to ensure the accuracy of the CNC machining center operation rules when the tool is connected.
6. If you find that the machining allowance is too much during the machining process, you must use "single block" or "pause" to reset the X, Y, and Z values to zero, then manually mill them out and then shake them back to the "zero point" to let it go on its own run.
7. Operators are not allowed to leave the machine tool during self-running or regularly check the operating status of the machine tool. If they need to leave halfway, they must designate relevant personnel to check.
8. The aluminum slag in the machine tool must be cleaned before the light knife sprays oil to prevent the aluminum slag from absorbing oil.
9. Use air to blow as much as possible in the roughing program, and spray oil in the light knife program.
10. After the workpiece is off the machine, it must be cleaned and deburred in time.
11. When off work, the operator must do a timely and accurate handover to ensure that the subsequent processing can be carried out normally.
12. Before shutting down, ensure that the tool magazine is in the original position, the XYZ axis is stopped in the center position, and turn off the power supply on the machine operation panel and the main power supply in turn.
13. When encountering a thunderstorm, the power supply must be cut off immediately to stop working.
In addition to the above points, there are many things that we need to pay attention to from time to time. The system should be paid attention to, and the machine should also be maintained. In fact, most of the time, the machine will be broken. To a large extent, it is caused by improper operation by the user. Regular maintenance of the machine. Do not pay attention to checking the machine before starting the machine, and do not preheat it. Due to the bad environment, the machine has been in dark and humid, dusty, oily and various other chemical liquids for a long time due to the bad environment, and the production personnel move the machine without authorization. , It is easy to cause machine problems. In fact, if these problems are dealt with in a timely manner, the service life of our machines will definitely be much longer, the machining accuracy and performance of the machines will be as new as new for a long time, and the loss will be greatly reduced. The replacement frequency of components is reduced, saving a lot of time and cost
